Why animal evolution mirrors wheel design

DUKE (US)—While the evolution from the Neolithic solid stone wheel with a single hole for an axle to the sleek wheels of today’s racing bikes can be seen as the result of human ingenuity, engineer Adrian Bejan says it also represents how animals, including humans, have come to move more efficiently and quicker over millions of years on Earth.

Bejan, professor of mechanical engineering at Duke University, argues that just as the design of wheels became lighter with fewer spokes over time, and better at distributing the stresses of hitting the ground, animals have evolved as well to move better on Earth.

In essence, over millions of years, animals such as humans developed the fewest “spokes,” or legs, as the most efficient method for carrying an increasing body weight and height more easily.

“This prediction of how wheels should emerge in time is confirmed by the evolution of wheel technology,” Bejan says. “For example, during the development of the carriage, solid disks were slowly replaced by wheels with tens of spokes.”

The advantage of spokes is that they distribute stresses uniformly while being lighter and stronger than a solid wheel. “In contrast with the spoke, the solid wheel of antiquity was stressed unevenly, with a high concentration of stresses near the contact with the ground, and zero stresses on the upper side,” Bejan says. “The wheel was large and heavy, and most of its volume did not support the load that the vehicle posed on the axle.

“If you view animal movement as a ‘rolling’ body, two legs, swinging back and forth, perform the same function of an entire wheel-rim assembly,” Bejan says. “They also do it most efficiently—like one wheel with two spokes with the stresses flowing unobstructed and uniformly through each spoke. The animal body is both wheel and vehicle for horizontal movement.”

Bejan’s analysis was published in the American Journal of Physics.

“An animal leg is shaped like a column because it facilitates the flow of stresses between two points—like the foot and hip joint, or paw and shoulder,” he adds. “In the example of the Neolithic stone wheel, the flow of stresses is between the ground and the whole wheel.”

Bejan believes that the constructal theory of design in nature, which he started describing in 1996, predicts these changes in the wheel and animal movement. The theory states that for a design (an animal, a river basin) to persist in time, it must evolve to move more freely through its environment.

Since animal locomotion is basically a falling-forward process, Bejan argues that an increase in height predicts an increase in speed. For a centipede, each leg represents a point of contact with ground, which limits the upward movement of the animal. As animals have fewer contacts with ground, they can rise up higher with each stride.

“The constructal theory shows us this forward-falling movement is dictated by the natural wheel phenomenon, which is required for the minimal amount of effort expended for a certain distance traveled,” Bejan says.

An earlier analysis by Bejan showed that larger human swimmers are faster because the wave they create while swimming is larger and thus carries them forward faster.

While wheel-like movement evolved naturally, it also describes what Bejan likes to call “nature’s gear box.” Humans have two basic speeds, Bejan explains—walking and running. A running human gets taller, or higher off the ground, with each stride, which increases his speed.

A horse has three speeds—walk, trot, and gallop.

“The horse increases its speed by increasing the height from which it falls during each cycle,” Bejan says. “Then, from the trot to the gallop, the body movement changes abruptly such that the height of jump increases stepwise for each stride. Nature developed not only wheel-like movement but also mechanisms for changing speeds.”

Bejan’s research is supported by the National Science Foundation and the Air Force Office of Scientific Research.

More news from Duke:

Related Articles