antenna_1

Antenna shrinks. Phone soon to follow?

U. MICHIGAN (US) — A new way to mass produce extremely small antennas may lead to the next generation of tiny wireless gizmos.

The antenna is typically the largest wireless component in mobile devices. Shrinking it could leave more room for other gadgets and features, says Anthony Grbic, an associate professor of electrical engineering and computer science at the University of Michigan.

Grbic and Stephen Forrest, a professor of materials science and engineering and physics, led the development of the hemisphere-shaped antennas, which can be manufactured with innovative imprint processing techniques that are rapid and low cost.

The finished product is 1.8 times the fundamental antenna size limit established in 1948 by L.J. Chu. The dimensions of this limit vary based on an antenna’s bandwidth.

“Ever since the Chu limit was established, people have been trying to reach it. Standard printed circuit board antennas don’t come close. Some researchers have approached the limit with manually-built antennas, but those are complicated and there’s no efficient way to manufacture them,” Grbic says.

“We’ve found a way to reduce the antenna’s size while maximizing its bandwidth, using a process that’s amenable to mass production.”

The researchers’ prototype operates at 1.5 gigahertz, in the frequency range of WiFi devices as well as cordless and mobile phones. The antenna is 70 percent efficient and ten times smaller than conventional antennas, Grbic says. It has three times the conductivity of similar devices produced by 3-D ink-jet printing techniques, a process that serially writes the antenna geometry.

This new method is a very general process, says Carl Pfeiffer, a doctoral student and first author of a paper on the work being presented at the 2011 IEEE International Symposium on Antennas and Propagation.

“It can be used to fabricate antennas that are of a wide variety of sizes, shapes, frequencies, and designs,” Pfeiffer says. “Basically if you tell me the data rate that is required for a particular application, I can make an antenna that does this while at the same time being as small as possible.”

Beyond consumer electronics, this work could be useful in wireless sensing and military communications. Wireless sensor networks could be used for environmental monitoring or surveillance.

The work was funded by the Department of Education’s Graduate Assistance in Areas of National Need program, the National Science Foundation, and the U.S. Air Force Office of Scientific Research. The University of Michigan has licensed certain rights involved in this research to Universal Display Corp. Forrest holds an equity interest in, serves on the scientific advisory board, and is a consultant for the company.

More news from the University of Michigan: http://ns.umich.edu/

chat3 Comments

You are free to share this article under the Creative Commons Attribution-NoDerivs 3.0 Unported license.

3 Comments

  1. bob smith

    Ok the bandwidth is from infrared through visible and the data rate is whatever the suns photon delivery rate is.

  2. Earl davis

    @bob smith: Nice!

  3. chris

    I have deep respect for Dr. Grbic, but this antenna looks like one presented at an IEEE IMS workshop in Boston two years ago. Since Dr. Grbic is involved, why aren’t there any metamaterials?

We respect your privacy.